Houston Commercial TV Installation
A row of menu boards is not four mounting jobs, it is one layout: a single snapped line for the rail centers, equal gaps carried the length of the run, and every panel sitting at the same standoff so the row reads flat from the counter. A conference display is a sightline problem measured from seated head height at the far end of the table. A bar wall is a load problem, because block, steel stud, and a room full of people all pull in different directions. We work through each of them the same way, in whatever hours keep your floor open.
Start here
What the work includes
Done properly or not at all
- 01Rows and video walls off one line
- Before the first anchor goes in, a laser and a chalk line establish the rail height for the entire run, and the gaps between panels are set with physical spacers rather than a tape measure and optimism. A row hung screen by screen always shows it; a row hung off one reference never does.
- 02Conference rooms and offices
- Display height is measured from seated eye level at the far end of the table, not taken from a chart, and the cable is landed where your equipment actually lives, whether that is a floor box, a credenza, or a wall plate behind the panel. Where another trade owns what plugs in, we set the pathway and the plate and leave clean terminations for them.
- 03Bars, restaurants, and gyms
- High walls, concrete block, steel stud, and tile over backer, often above head height and often above the counter. Anchors are rated for the load with the material factored in, cable is tied off out of reach, and the mount is chosen for how the panel will be adjusted later rather than only for how it hangs on day one.
- 04Multi-site work that stays consistent
- Working from your drawings, the rail height, panel spacing, and cable treatment carry from the first location to the last, so the tenth room matches the first. Visits are built around opening hours, and each site is left finished rather than half-staged for a return trip.
Pricing
The number is settled at booking
Answer a few questions about the panel, the wall it is going on, and where the cable should run, and your total appears in the booking flow before you pick a time. Nothing is charged until the work is finished.
FAQ
Commercial TV Mounting questions
What keeps a row of screens reading as one line instead of four separate mounts?
One reference and one set of spacers. The rail height for the whole run comes off a single laser line, the gaps are set with physical spacers, and every panel is checked at the same standoff so the row sits in one plane. Setting each screen on its own is what produces a stepped row.
What anchors go into concrete block or a steel stud wall?
Block takes a sleeve or wedge anchor set into the face of the unit rather than the mortar joint, drilled slow with dust pulled at the hole. Steel stud takes hardware rated for shear and sized to the gauge, and on a heavy panel a plywood or steel backer spanning two studs carries the load instead.
Does low-voltage cable have to run on the surface in a commercial building?
Not always. Where the wall construction and the local requirements allow it, signal and low-voltage runs go inside the cavity between plates. Where they do not, the run is carried in tight raceway with square corners and a consistent height, and anything beyond low voltage is left to your electrician.
Will the work happen outside our service hours?
Yes. Before opening, after last service, and the slow stretch between the two are all normal windows for this kind of work. Tell us which hours have to stay clear and the visit is built around them.
What does a rollout across several locations involve on your side?
A walk of the drawings or of the first site, an agreed rail height and cable treatment, then the same setup repeated site by site. Heights, spacing, and terminations stay identical across locations, which is the part that gets noticed once the rooms are seen side by side.
Does the number get settled before anyone arrives?
Yes. A single display is priced in the booking flow and that figure holds. A multi-screen or multi-site job gets a written scope and an agreed number before any hardware comes off the truck.
More from Houston TV Installation
Commercial TV Mounting, booked in about two minutes
Enter your ZIP code, answer a few questions about the panel and the wall, and your number is settled before you pick a time. It takes about two minutes.
Prefer to skip ahead? Go straight to booking